Crashes into back bed wire
-
Hi,
My printer (ender 3) with the Duet WIFI completes the probing before a print (with BlTouch). When it goes to make the first line it keeps going and crashes into the wire for the bed at the back of the bed.
I put in the correct print bed size when setting up but it may be wrong. I am not sure where to check or which config file to see the size.
-
You need to look in your config.g file. Here are my entries for my ender 3.
; Axis Limits
M208 X0 Y-17 Z0 S1 ; Set axis minima
M208 X235 Y224 Z220 S0 ; Set axis maxima -
@lodger Thank you that fixed it. Do you know where I can change the extruder hight in the config file? mine is floating too high. I then get this as well: Extruder 0 reports too little movement
-
Do you mean Z off set ?? are you running a probe or a switch
-
@lodger Running probe. I fixed it. Missed a step before.
