Wifi seems to have died
-
I am using the Duet wifi board v1.04. A few minutes ago, I went in to the config.g file to tweek one of the settings. I saved it and the board rebooted. When it came up, I could not connect to it. The blue light that is usually on the wifi chip is out. The only thing I changed in the config.g file was the bed prob definition.
Anything I can look at, or am I just screwed?
-
pull the sd card out and put it in your computer.
you can edit the settings there and then put the card back. -
Editing the SD is not the issue. I did that successfully. The problem is that when I restarted the Duet, there was no wifi connectivity. (could not connect and the blue light does not light). Without the wifi, I have no way to control the board as far as I know.
BTW, I did take the SD card to the computer and backed it up (as I always do when there might be an issue) and it was read fine. But, still, there is no wifi
-
disconnect the power and connect to the duet over usb.
then you can send the commands over serial and get more info. -
Well I said I successfully edited the config, but I didn’t realize that the config.g file was zero bytes after the save. I’ve been having some issues with loosing the connectivity quit often and I guess that happened during the save.
I grabbed the config.g.bak but unfortunatly without my last setup for the probe. Oh well. Set it up once, I can do it again.
Thanks for the suggestions.
Charlie
