Imputshap8ng stops when collecting data
-
Hello everyone,
I just installed my accelerometer, after some tries the sensor was found by the duet with the m955 command.
When I start the data collection, the print head makes a move from the center along the x axis. But the nothing happens anymore.
Do you have an idea what the problem might be?
Kind regards
Milan -
@Milan-R Inputshaping sampling on RRF is based on a single move. That's different to Klipper where the frequency spectrum is walked.
Are you using the input shaping plugin ? Do you see data collection happening?
-
@oliof
Hello,
Thanks for the answer.
I use the plug in and I don't see any data that was collected.
Or at least I don't know where to find it.It is possible to do a x and a y move or a combined move.
When I say I want a x and a y move. It does only the x move but does not start the y move, even though it is in the queue. I think I have seen a picture, where there is a check mark in front of the move before it starts the next move.I just see the playbutton for the first move and a sun or a clock in the line of the second move,but it never changes
Best regards Milan
-
@Milan-R
Hello,
so today i had some time and tried it again. It worked at the first try and i can see data now.
I changed nothing. But now it just works.
