Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Can't install 3.5rc1 on USB powered Duet 3 Mini

    Scheduled Pinned Locked Moved
    Beta Firmware
    1
    1
    65
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Exerqtorundefined
      Exerqtor
      last edited by

      I just received my replacement v1.02 Duet3 Mini and thought i'd update it to 3.5rc1 before putting it in the machine, and it didn't work out to well 😂

      I first tried going from RRF 3.4.0 as the board came shipped, and it wouldn't boot after the install. So i rolled back to 3.4.0 and flashed to WifiServer 2.1b4 incase that made some issues, same problem.

      Tried installing 3.5b4, no issues. Then I tried going from 3.5b4 to 3.5rc1, same issue.

      Reinstalled 3.5b4 and put the board into the machine and hooked everything up.

      Booted the machine and checked that everything worked, which it did.

      Figured i might as well try to instal 3.5rc1 while the machine is VIN powered (24V), this time it installed without issues.

      Thought this was worth mentioning 😅

      1 Reply Last reply Reply Quote 0
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA