IDEX Head crash when doing G29 with U axis

[kuon]

@Proschi78 Yeah, but the point is that it shouldn't matter.

I hope all axis, at this point no tool is selected.

I expect G29 to be able to probe using the U axis.

Only the first point work, then the head goes crashing on X carriage.

[Proschi3D]

@kuon Can it be that he makes t1 inactive after confirming, or even automatically switches to t0?

[kuon]

@Proschi78 No, because if I select T1 before doing G29 it works.

[Proschi3D]

@kuon Yes I read that. But if t1 is not selected before the g29 command, does it then switch to t0 or become inactive after the first acknowledge ?

[kuon]

@Proschi78 No, G29 doesn't affect selected tool.

[Proschi3D]

@kuon do you have a mesh.g ?

[kuon]

@Proschi78 No. mesh.g doesn't exist.

[Proschi3D]

@kuon I think if there is a mesh.g where the tool is called first, the g29 command will work

[Proschi3D]

@kuon did it work now

[kuon]

@Proschi78 As I said, if I select the tool before doing G29 so, T1 + G29 it works. But I think it should work without T1 as I specified U axis in M557. Also it should not go crash in other tool. Perhaps @dc42 can chime in. I'd be happy to try to help debug the issue.

[Proschi3D]

This post is deleted!