Mid print extrusion issues now phase b error
-
I pulled a print off my bed this am after letting run overnight. Last part of print has major extrusion issues. Now when I try to extrude I get phase b errors. Clicking and no extrusion. If I connect the extruder to the next driver as T1 - all seems fine. Is it likely a bad driver / that my board is starting to go? I had the same thing happen to one of my fan connections a year or so ago. Had to use a separate fan port. Thoughts?
-
@jaymcd0626
It's possible that the driver is gone, but equally possible that there was a bad connection and moving the wiring corrected that.
I'd swap everything back to the original position and config and see if the error returns.
If the driver is actually faulty, it should error almost immediately (or at least when it gets to temp).