Wiring
-
Hello
I have a question in regards of the stepper motor wiring.
On the drawing of the Duet3 board I can see that
A2 = Black
A1 = Green
B2 = Blue
B1 = RedBut If I take a look at the MOONS MS17HD4P data sheet The colors of the wires are different from the Duet, and on the Hemere extruder another set of colors.
Could I care less about the colors of the wires and just concentrate on the drawings?
An example.
A Moons stepper is catorised like this
1A
3C
4B
6DWould it then be
Duet3 = Moons
A2 = 1A
A1 = 3C
B2 = 4B
B1 = 6DI am in doubt and I hope that you can help
-
-
Thanks for the fast reply
Okey, I will not be concerned about the colors then. To me they could all be black.
I will treat them as pairs.Maybe you can answer one more question for me.
Connecting the Fans to PWM OUT 4, 5 and 6.
My fans are 2 pins. And in regards of the description I will have to connect them toV_OUT_LC_1 pin (+ve) and the OUT_n_NEG pin (-ve).
But where is the OUT_n_NEG Pin. My thoughts is that it would be GND. Is this correct?
-
@heide these ones
-
Then I have made it wrong. I am happy that it has not been powered on just yet. Thanks