no filament discharge charge 3.4RC1
-
serious problem when activating the extruder to load or download filament, in dweb controll do not activate the speed keys and millimeters see figure. I repeat it is useless to add a thousand news if then the heart of the firmware is not good and always lacks something fundamental. doing so does not appear serious and reliable. I would make a software working 100% for its fundamental features then comes the rest, being careful not to unbalance everything.
duet 3 v1.01
firmware 3.4 RC1
-
Thank you for testing. This version is a release candidate (thus the letters „RC“), not the final release of RRF v3.4.
@massimilianoconti said in no filament discharge charge 3.4RC1:
I would make a software working 100% for its fundamental features then comes the rest, being careful not to unbalance everything.
Finally, an expert! Go on, nobody hinders you to make up your own branch of RRF on GitHub. It’s open source, you know.
-
ok of nothing
-
I'm not an expert I'm just an electrical engineer but personally I face a project with this logic keeping the fundamental hinges 100% additional things instead in the background such as not to create malfunctions to the rest
-
@massimilianoconti Extruder controls won't be activated unless the hotend is above 170C, IIRC, or cold extrusion is enabled with M302, https://duet3d.dozuki.com/Wiki/M302
-
Try clicking on “Tool 1” to activate it. It appears Tool 0 is the active tool.
-
I know thanks does not respond well the command compared to before now they are both activated simultaneously. there is something wrong. if I go from the dual panel it works for example but we will see thanks. I did not quite understand if the developer of the firmware is only Mr. Dozuki or beyond people.
