WiFi doesn't start up after upgrading to RRF3.3
-
Hello all!
I tried updating my duet 2 wifi to RRF 3.3 coming from RRF 3.1.1 using Duet2and3Firmware-3.3.zip.
I uploaded the zip file via DWC into the /sys folder all seemed to work fine but the wifi module doesn't connect to my router anymore.
I hooked the board up via USB and if I issue a M552 S1 it connects properly.
But once I restart the printer it doesn't connect again.Could anyone give me a hint what I've done wrong?
Thanks in advance! -
@gueee78 did you have the command M552 S1 in your config.g ? Please post the result of M98 P"config.g" and your config.g file
-
@siam thanks for the reply, your suggestion to issue M98 P"config.g" lead me to my mistake.
I had a typo in the IP configuration.
Thanks a lot!
