1LC and 4-wire fan - problem with tach
-
Hi folks,
I have problems with my 4-wire fan from Sunon (24V) connected to a 1LC toolboard. I can't get it working like with the 6HC. When I remove the 121.out1.tach, then it works properly.
; Main fans M950 F0 C"!121.out1+121.out1.tach" Q500 ; Part cooling fan M106 P0 S0 B0.1 H-1 ; Default off; booststart for 0.1s (B0.1); thermostatic control offAll other sensors, fans, extruder and microswitch are working. The status led is blinking slowly.
Thank you,
Pierre -
@medicusdkfz you only need to have the 121. once
so change it to; Main fans M950 F0 C"!121.out1+out1.tach" Q500 ; Part cooling fan M106 P0 S0 B0.1 H-1 ; Default off; booststart for 0.1s (B0.1); thermostatic control off -
@jay_s_uk Thank you! You made my day...
-
Do I have to perform a new autotune with my Mosquito hotend with the new 1LC?
-
@medicusdkfz I would advise it
Use M303 T0 S240 (obviously adjusting the T value to the right tool and the S value to what temp you want to tune to) -
Thank you,
Pierre -
It's often the little things that make life difficult: My extruder didn't make a sound on the 1LC and, as is always the case, you first check the crimp connections, the cables, the correct connections, the configuration - and everything several times. One is almost inclined to rebuild everything again, then one reads the last of countless articles and realizes that it was only a small parameter... Like above with the fan.
Kind regards, Pierre
