Fan Selection on Paneldue

NeueKlasse

Is it possible to change the Active Fan on the PanelDue?
i think i remember that in earlier Version this was possible,
but now on the Status Page it's just "FAN" where i can set it from 0-100% (which is normally
the Partcoolingfan, at least on my Chiron)
i wanted to control every Available fan on the PanelDue.... FW PanelDue-3.4.0-pre2

mfs12

Hey @NeueKlasse, i had a look into the sources. I don't think it was ever possible.

At the moment you can only adjust the speed. Although you could write a macro to reconfigure your fans. Command M563 might be helpful.

Please check the gcode specification

NeueKlasse

@mfs12

then i was wrong, i thought i changed the fan sometime... i'm looking forward to a
"Fan Change" possibility

Thank's for the Advise, with M563 it's possible to get around that function