Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Piezo Orion stopped working after update to RRF v3.3

    Scheduled Pinned Locked Moved Solved
    General Discussion
    1
    2
    100
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Recoilundefined
      Recoil
      last edited by

      Hi folks,
      I updated my delta printer with a Duet WiFi to RRF v3.3 from v2.05, I know a few things changed in the config one of those M558.
      I had the piezo working correctly before with M558 P5 I1 R0.4 F300 X0 Y0 Z0.
      I changed it to M558 P1 C"zprobe.in" I1 R0.4 H5 F300 X0 Y0 Z0 it does try to probe but I get an "Error: Probe already triggered at start of probing move" I can see under "Z probe" in the dashboard it shows highlighted in red 456 and when I tap the piezo goes down to zero and back up again it does detect the taps.
      I have tried changing I1 to I0 in different combinations with P1, 2, 5, and 8 but I can get it to work I still get the same error.
      Could you folks guide me on what are the correct settings that I should be using? Thank you all for your help.

      1 Reply Last reply Reply Quote 0
      • Recoilundefined
        Recoil
        last edited by

        I found the solution "M558 P8 C"^!zprobe.in" R0.4 H5 F300 X0 Y0 Z0" That did it 🙂

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA