toolboard fail autoleveling
-
hi !
I am using a tool board with 3.3beta2+2. I have a bltouch connected to it.
My issues is than the head move to high from the bed (twice the dive height). So it always return "Error: Probe was not triggered during probing move".
The problem it is not because the dive height is to low, but because the firmware move the head 20mm of the bed instead of 10mm (=one dive height) and for the firmware this 20mm is 10mm like it "eat" 10mm for no reason, so after the 0 point is 10mm above the bed.
I hope you enderstood myself.My prob config:
M558 P9 C"^122.io0.in" H10 F120 T5000 G31 K0 X-85 Y47 Z0 ;prob offset M950 S0 C"^122.io0.out"
-
@pseud3mys said in toolboard fail autoleveling:
My issues is than the head move to high from the bed (twice the dive height).
this has been fixed in 3.3.0
I suggest updating to 3.3.0 and seeing what happens then -
@jay_s_uk It work thank you !