V 3.2 Firmware Heatbed PID tuning doesn't seem to finish
-
I ran the M303 command to re- pid tune after upgrading to V3.2. The tool 1 extruder tuning seemed to work fine but the bed tuning seems to get stuck on phase 4 - or is taking an extraordinary time to finish.
This is the command I sent - M303 H0 S60.
Thanks
Jay
-
@jaymcd0626 can take up to 1 hour!
-
hmm - ok thanks
-
@PCR said in V 3.2 Firmware Heatbed PID tuning doesn't seem to finish:
@jaymcd0626 can take up to 1 hour!
.........Or with a 10mm thick, insulated bed more like 2 hours (I know from experience).