Duet2 WiFi Firmware on Raise 3d E2 ?

[Proschi3D]

@dc42 can I go back from V3.0 to V2.02 that easily?

[jay_s_uk]

@Proschi78 that'll be why the downgrade didn't work then.
use the IAP file dc42 linked to and the firmware from my google drive

[Proschi3D]

@jay_s_uk ok i will try today at noon

[Proschi3D]

Hello everyone here who helped me. I was able to successfully install a version that was before 2.02. Then the printer could be updated via the Raise software. The whole thing was worth it for me, because now I have the possibility to control it via octoprint for whatever reason. thank you again

[Proschi3D]

Do you think an original duet2 Wifi would work with the hardware components?

[Veti]

@Proschi78

not with the display, but you only did a third of the firmware update of rrf3. it might be that you could update the board to 3.1.1

[Proschi3D]

Yes that may be, but then I have no chance to use the display and control board. I am currently having the problem that the Gcode is being sent from the control board to the motionboard. This causes errors and the printer pauses printing, a stutter.

[Veti]

or if you want to invest some time and since you already have an octoprint server, run klipper with mainsail os.

[Proschi3D]

Here are two videos of the problem

https://youtu.be/esYPmuN4yWE

https://youtu.be/oTwaAePwyBw

[Veti]

@Proschi78

I am currently having the problem that the Gcode is being sent from the control board to the motionboard. This causes errors and the printer pauses printing, a stutter.

do you mean octoprint by control board to motionboard?

[Proschi3D]

No, I connected Octoprint directly to the Motionboard. As a result, I have no way of controlling it directly at the printer.

[Veti]

@Proschi78

since you are running stock configuration now, i suggest you take that up with raise 3d.

[Proschi3D]

Do you think the error has been fixed with an original duet wifi + deux5 + display? The rest of the hardware would have to take part, since it is now based on a duet motionboard

[Proschi3D]

I ordered a duetwifi. I'm curious how it goes

[Proschi3D]

The duet wifi came today. I have a question about this, can I connect a second x axis instead of the second z axis?

[A Former User]

Sure, board doesn't know what you're connecting, and firmware only cares about the config.

The two headers for the driver labeled Z are in series, and doesn't require any special configuration other than assigning driver 2 to x instead of z. To actually use two drivers you can follow the independent z axis instructions, just assign the drivers to x instead of z.

Alternatively you can also wire two motors in series or parallel to any of the other outputs with custom wiring as needed.

[jay_s_uk]

@Proschi78 did you ever get any reply from raise3d about the pinout/schematic of the board?

[Proschi3D]

@jay_s_uk No, unfortunately not

[jay_s_uk]

@Proschi78 disappointing

[Proschi3D]

@jay_s_uk said in Duet2 WiFi Firmware on Raise 3d E2 ?:

disappointing

yes it upsets me. but what should i do