Duet2 WiFi Firmware on Raise 3d E2 ?
-
so it seems to be running rrf2. not sure if they modified it.
if you want to risk it, you can update the firmware with rrf3
see
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware
Fallback procedure #2 -
@Veti this was not a good idea.
the printer does not start anymore -
This should get you back up and running
https://drive.google.com/file/d/1X7L8mZ71x0eZNYgMeaI8VubTBc1Uk9uV/view?usp=sharing
i have built it from the raise3d sources -
(>>) Error: M997: In-application programming binary "Duet2CombinedIAP.bin" not found<LF>ok<LF>Error: M997: In-application programming binary "Duet2CombinedIAP.bin" not found<LF>ok<LF>
-
What version are you trying to flash so we can point you at the right file
-
@Proschi78 said in Duet2 WiFi Firmware on Raise 3d E2 ?:
RepRapFirmware for Duet 2 WiFi/Ethernet version 2.02(RTOS) running on Duet WiFi 1.02 o
-
these data are on the original sd card
-
@jay_s_uk do you think version 3.3 would work with the bin file you gave me?
-
@Proschi78 that bin file is 2.02 built from the raise3d sources.
If you want to install RRF 3 you first have to go to 3.0 using the zip file from here https://github.com/Duet3D/RepRapFirmware/releases/download/3.0/Duet2and3Firmware-3.0.zip -
@jay_s_uk 3.0 dont work on the printer
-
you can still go klipper with mainsail
that will give you a good alternative. -
@Veti first I want to get the board running again
-
have you tried these firmwares
https://www.raise3d.com/download/motion-controller-board-firmware-all-versions/
-
@Proschi78 the iap from here should work https://github.com/Duet3D/RepRapFirmware/releases/download/2.03/iap4e.bin
-
@jay_s_uk with 2.02 ?
-
@Proschi78 yes
-
@jay_s_uk ok i will test it
-
-
you need to rename it to match the missing file
-