Flow calibration issue
-
After flow calibration test (Delta printer, Simplify3D, 20X20 cube, 2 perimeters of 0.48 each), all walls of the model were different.Instead of 0.96x0.96x0.96x0.96, I got 0.97x1.01x1.03x0.96.
Please tell me where the problem might be and how to fix it?
-
I have the same issue on my coreXY.
-
Print this with 1 perimeter in vase Mode
check of its the same result
-
@lui2004 Yes, "vase mode" shows proportionally same result.
-
On my delta (1m tall) when I had this issue the culprit lies in 3 things:
- geometrical (tower bended/twisted or not squared to the bed)
- belts tension not properly settled. (the belts must not be tied to death)
- Z-height not well calibrated. (also if auto cal end properly)
Those could affect also the 1st layer. Inspecting it , maybe it come a little more squished where walls are more thick?
-
For your own sanity, do a decent length free air extrusion and measure it for roundness. I've chased a similar thing only to have it be that my nozzle had become oval shaped.
-
@lord-binky Thanks for your opinion, but I guess I have a slightly different view on accuracy.