Swap Ethertnet for Wifi
-
Hello i just swap my wifi board for Ethernet i change my config file for ethernet and now i can control nothing on my printer
and tool show just with out temp it's wierd
-
@matej1006 Post you config file. Make sure the config file is setup for the firmware version you have. The config for version 3 won't work for version 2.
-
@matej1006 said in Swap Ethertnet for Wifi:
i change my config file for ethernet
what did you change? afaik you shouldn't have to change anything at all,
M552 S1enables networking regardless of it being wifi or now ethernet. -
@bearer i did and didn't work
-
@Stephen6309 said in Swap Ethertnet for Wifi:
version
i know that i update to 3.2 beta 2 which was my last working update on wifi board
-
do you desoldered the wifi and put in the ethernet controller? is that correct?
-
no i order new duet board
-
did you update the firmware version on the new board? you config will only work with a version 3 firmeware.
-
can you share file with me please to see if did im a not shore
-
@matej1006 said in Swap Ethertnet for Wifi:
can you share file with me please to see if did im a not shore
i dont understand what you mean.
the info on how to update is here
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware -
@Veti that work for me thanks
