problems while probing

Veti

@peterartechno said in problems while probing:

Duet wifi 2.03

that doesnt exist.

post you config.

possible differences could be speed of the z axis.

peterartechno

Sorry, duet web control 2.07

config.g

Here is my config.g file.

peterartechno

I found that in config, my max speed is limited to F180, while the X-home and Y-home use F6000. That works fine. In my config.g file I use F180, is that not good?

peterartechno

@Veti

Did you find anything in the onfig.g file hat might explain the problem?

Veti

@peterartechno said in problems while probing:

duet web control 2.07

the correct version dwc is 3.1.1 for firmware version 3.1.1

i dont have external stepper motors but i was always under the impression that you need to configure the timing for them
something like this (this depends on the stepper driver used,)
M569 P5 T2.5:2.5:5:0

jay_s_uk

yes, the timings need setting for them.
Which external drivers are you using?

peterartechno

@jay_s_uk

I am using ES-D808 external stepper drivers with Nema32 stepper drivers ( a closed-loop system).

The weird thing is that the left axis is not working, but the right one has no problems. This made me think that that was not the problem, the timing

Veti

http://www.leadshine.com/uploadfile/down/es-d808d_v0.1.1.pdf

For reliable response, pulse width should be longer than 2.5μs.
, DIR signal should be ahead of PUL signal by 5μs

jay_s_uk

@peterartechno said in problems while probing:

ES-D808

yea, as @Veti says
you'll definitely need timings on those. you may think they are fine but then you'll have movement issues just like you're seeing.
I also use similar external drivers and definitely need timing to get consistent results.
You'll need M569 T2.5:2.5:5:5 on each driver thats external

peterartechno

Thanks! Do I need to change the M569 T2.5:2.5:5:5 to something like T2.6:2.6:65:5?

Where in the config.g file do I put this?

Veti

@peterartechno
append T2.5:2.5:5:5 to the existing M569 entries

try with that for now

jay_s_uk

@peterartechno try out with the M569 timings I gave you above. that should be ok. Worst case you could add half a microsecond but I dont think it would be needed.
I would guess that your current M569 commands looks something like

M569 P0 S0

change to

M569 P0 S0 T2.5:2.5:5:5

You only need to do this to the drive numbers that are the external drives

peterartechno

@jay_s_uk
Thanks

I use 2 X-motors, 1 Y-moor and 2 Z-motors, all with external stepper drivers but that particular one is the only one with problems. I am going to try it right now!

Veti

@peterartechno

do add it to all the external drivers. it will save you headache in the long run

peterartechno

@Veti @jay_s_uk

Thank you so much! It worked! Finally worked out the problem I encountered weeks ago!
You have both made my day

kind regards,

Peter