Will M118 trigger a webhook?

ericlmccormick

I want to figure out a way to trigger an event so that I know my print is done or paused due to a filament issue. I noticed that m118 supports http but there is very little information.
Can m118 be used to trigger webhooks?

not unless you implement it in DuetWebControl. As in the message will be sent to DuetWebControl client if connected

ericlmccormick

@bearer so sending an http message is a pop-up in the browser?

i don't recall the actual presentation as its been a while, but you can easily run M118 from the console in DWC and see the result.

ericlmccormick

@bearer yeah, just a pop-up in the duet control page.