Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Bed compensation

Locked

Firmware installation

1

2

448

Log in to reply

undefined

cbusillo
last edited by

Hi all. I have followed the directions to the best of my ability. My printer has successfully completed a G29 and saved the resulting height map.csv. When I run M122 it says bed compensation none. I'm not sure where to start troubleshooting. M122 says no compensation after G29 or G29 S1.
1 Reply Last reply
Reply Quote 0
undefined

cbusillo
last edited by

Oops, I posted in the wrong place. Can someone fix that?
1 Reply Last reply
Reply Quote 0

1 / 1