Not homed after print
-
Hi,
Im almost done with my duet2 meets cr10 project. Just in time, the ratrig will arrive soon.
My first print was OKish and the first questions come up. All three axes are in "not homed" state. Is that the plan or a bug in my config? Can I change that?
Cheers, Chriss
-
I'd check the end gcode, if its doing something like turning the motors off, then the firmware can't be sure of it's position and will report not homed.
-
Very good point, thanks. I think that this is the case, I will trun that off. I do not like that anyway.
