Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    PA and extruder noise

    Scheduled Pinned Locked Moved
    Tuning and tweaking
    1
    1
    446
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Mike_Fundefined
      Mike_F
      last edited by

      Hi,

      Just about getting my upgraded Kossel Pro dialed in. I have just printed a 3DBenchy and it has come out really good in PETG. I was using relative extrusion, pressure advance set to 0.1 and I reduced my retraction from 5mm to 3mm. Printing was very impressive and clean but I noticed my extruder was clicking quite a lot. I am using a BondTech, geared extruder (the best in my opinion) and I am assuming the clicking is from the gearbox as the pressure advance is commanding rapid reversals in direction. Although this is not too concerning at the moment, I wonder whether it will have any detrimental effect over a long period of time if I continue to use PA?

      OpenBeam Kossel Pro, Duet WiFi, 5" PanelDue, BondTech extruder, E3Dv6 1.75mm Hotend.

      1 Reply Last reply Reply Quote 0
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA