Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Is this Repairable?

    Duet Hardware and wiring
    3
    3
    759
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • BMMalundefined
      BMMal
      last edited by

      While installing Mechaduinos on my machine, I needed to supply them with 5V. My intent was to get this off of the 5V pin for the PanelDue. Unfortunately, I mixed up the Vin and 5V on the Mechaduino end resulting in connecting 24V into the 5V power system of the Duet WiFi… Not a good day. Now the heaters are stuck on and I cannot connect to the board. I'm wondering if there is any saving this or should I just cut my losses and get a new one?

      This appears to have damaged my Duex5 as well.

      Duet Ethernet - Most likely the most recent Edge firmware
      Duet X5
      7" Panel Due V2
      Cartesian, 4 Nozzles with Flex3Drives, Heated Chamber, Simple Switch Filament Sensing

      1 Reply Last reply Reply Quote 0
      • W3DRKundefined
        W3DRK
        last edited by

        I repaired a Duet WiFi that succumbed to the same fate and it needed practically every 5V device including the MCU and WiFi module replaced. Unfortunately, if I were to charge for that repair it would approach the same cost as just replacing the board…

        1 Reply Last reply Reply Quote 0
        • raykholoundefined
          raykholo
          last edited by

          @BMMal may I ask where you are located, and what you ended up doing?

          And @W3DRK, I sent you a PM, I have read that you sometimes have difficulty receiving messages on this forum, so please check.

          Thank you,
          Ray

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA