Duet3 6HC Config?
-
Hi,
I am looking for a basic code to start the configuration with the Duet3 6HC.
Someone could help me?
Thank you -
did you try https://configtool.reprapfirmware.org/General - choose Duet 3 and fill in the blanks?
-
How do I configure three heaters to display in web control?
Thanks
Chris
-
-
Ok, I made the changes from configtool but I still don't have the sensor displayed?
-
Check out my config.g for my ToolChanger. It is important to note that I am using CAN toolboards, but if you adjust the extruder drive mapping, heater output, and thermistor inputs it might be helpful:
https://github.com/bdtower8/Duet3ToolboardToolChanger/blob/master/sys/config.g
Line numbers that would need to be changed:
40, 61, 62, 66, 67, 71, 72, 76, 77, 83, 86, 89, 92
