M98 not working
-
I have a macro called Load_PLA.g placed in Macros/Filament/
If I call the macro directly, it works but if I enter M98 P"/Macros/Filament/Load_PLA.g" in the console I get an error message saying /Macros/Filament/Load_PLA.g not found.
I have Duet3 running RRF3 beta1.
Any ideas? -
Firmware is RRF 3.01 beta1!
-
Sorted it.
Although in DWC the Macros folder is spelt with a capital "M" , M98 requires it to be lower case "m"! -
@chas2706 said in M98 not working:
M98 requires it to be lower case "m"!
only on the Duet3 with SBC actually, all filenames are case sensitive there afaik. was talk of ways to solve/mitigate, but not sure of status.
-
@bearer
That makes sense then because my setup is with SBC.
-
Mabe some notes should be added to the relevant sections of the g-code wiki?
-
Yes It would definitely help to save time.
