heater fault

PaulHew

Post your config.g please.
What does your gcode console say?

Government_Bacon

Error: Heating fault on heater 1, temperature rising much more slowly than the expected 1.0°C/sec

Veti

M305 P0 T100000 B4138 R4700 ; Set thermistor + ADC parameters for heater 0
M305 P1 T100000 B4138 R4700 ; Set thermistor + ADC parameters for heater 1

B4138 is the default and most likely wrong for your thermistors. this can report the wrong temperature.

Government_Bacon

Error: Heating fault on heater 1, temperature rising much more slowly than the expected 0.9°C/sec
Error: Heating fault on heater 1, temperature rising much more slowly than the expected 0.7°C/sec

got to about 60c and got this error after changing the code
it dose heat up slow

0_1567271310702_config (1).g

Veti

could be a failed heating cartridge.

Government_Bacon

@veti it is a new heater and the last one did this

Veti

what hotend do you have?
the error message means when the hotend is powered on the temperature rises to slowly.

JRDM

Did you even tune the hot end? Once you got the tune, did you enter those values into the configuration file?

Government_Bacon

im using e3d volcano and i have auto tuned it

Veti

@government_bacon said in heater fault:

im using e3d volcano and i have auto tuned it

the values you have configured for the thermistor are not for an e3d vulcano. the e3d use semitec thermistors.
check the resistance of the heater catrige that you have the correct one for your voltage
https://matterhackers.dozuki.com/Wiki/E3D_Heater_Cartridge_Resistance

Government_Bacon

is there any pages that helps with this setup cant figure out what needs to be changed or added

Veti

in the configurator. when you click on the beta value for the thermistor a selection comes up. select the semitec thermistor.

Government_Bacon

got every thing to work now thanks