Can't connect to Duet2Wifi on Mac
-
maybe its easier to remove the sd card, and add your wifi stuff to the config.g file and put the card back in the duet?
-
@bearer
Already tried that using Atom. I've tried Chrome and Firefox -
Scrolling sounds like the board is reset for some reason, see if it behaves the same without the sd card when you run it. Could be worth trying to re-flash the firmware after that, but given that it shouldn't be necessary you may want to hold off on that.
-
@bearer
Hmm, got it connected. Haven't got a clue how. But it's connected. -
Change powersupply by chance?
Anyways, all that ends well and all that
-
@bearer
Same power supply. New 24v Meanwell. I just unplugged and replugged everything in about a half dozen times. Have no idea what finally got it working. Oh well. All's well and all that.. -
did you have the psu and usb connected at the same time?
-
@veti
No. Just the board plugged into the USB. -
Could be the USB port and/or cable was unable to supply enough power to let the board start up; if it started working after you had the config on the SD card and with the 24v supply that would make sense. But I'll stop beating a dead horse now
-
Back to not being able to connect to the Duet2Wifi on Mac