I would like to be able to manage my filaments spools collection directly from Duet.
I'm coming from a printer with octopi... I really like the Duet but I miss some features.
I know Duet can print from Octopi but if I switched to Duet it was (one of the reason) to remove the octopi .
There is a good Octopi extension (https://plugins.octoprint.org/plugins/filamentmanager/) and I would like to know if we could expect something similar.
Thanks

Yes... that's it .
So I see two solutions here.
1] Put A silicon around the head
2] Turn the head so the thermistor is not facing the air fan flow.
Or both

Yes... that's it .
So I see two solutions here.
1] Put A silicon around the head
2] Turn the head so the thermistor is not facing the air fan flow.
Or both

Yes, but I think I know what's happening...
I think the fan is strong and blows on the heater making the thermistor thinking that the heater is faulty while this is only coming from the air blowing.
Gonna put a silicon around it and test... Don't think now it's an electrical problem.

Hello everyone,
I have a 12V power supply on my duet Wifi/printer
I have recently added a 12V fan to cool the print (I was previously using a 5V fan)
So I moved the Fan Jumper and plugged the new fan and started a new print.
1st layer no problem (fan is off)
2nd layer, fan is switched ON but the Heater just stops...
I have tried again and each time the FAN starts , the heater stops to heat.
Have then unplugged the FAN (just to check) and everything is OK, no problem till the end of the print.
What could be the problem ?
Thanks
SR

I would like to be able to manage my filaments spools collection directly from Duet.
I'm coming from a printer with octopi... I really like the Duet but I miss some features.
I know Duet can print from Octopi but if I switched to Duet it was (one of the reason) to remove the octopi .
There is a good Octopi extension (https://plugins.octoprint.org/plugins/filamentmanager/) and I would like to know if we could expect something similar.
Thanks