Posts made by raf

Re: Add laser for duet2 wifi

Hello can somone make istructrions to toccect 3pins laser to Duex PWM controler?

Is the g32 command remembered by the system?

Because I have the impression that the factorials are falling apart, they don't go up well

Does duet3d fit duex2?

Current is 2,2A And the controlers have radiators and cooling. BUt when i give 2,4A after 1 hour of working there is a statement that the drivers are to hot.

My table consists of 4 plates 800x800 and it seems that they are not perfectly arranged relative to each other. But the hauler itself is heavy and the engines have to lift it up hard. Therefore, they must be 4. already have the voltage raised to 2.4A. And leveling G31 warms the drivers terribly. That's why I wanted to try leveling the table without constantly changing up and down while printing overloads the drivers

i have something like that o z probe

; Z-Probe
M574 Z2 S0 ; Set endstops controlled by probe
M558 P5 H5 F120 T800 I1 ; Set Z probe type to unmodulated and the dive height + speeds
G31 P500 X-5 Y-5 Z0 ; Set Z probe trigger value, offset and trigger height
M557 X1:1200 Y1:1200 S50 ; Define mesh grid

I have something like that

Leadscrew adjustments made: 4.442 3.913 0.827 -0.424, points used 4, deviation before 3.011 after 0.000

What this give me?

I cant put picture here.

Thank you very much for the hint.

I will do as you say

My config

onfig.g

M584 X2 Y1:9 Z5:6:7:8 E3;

M671 X500:10:500:10 Y500:500:10:10 S0,5;

bed.g

; bed.g

; called to perform automatic bed compensation via G32

;

; generated by RepRapFirmware Configuration Tool v2 on Mon Mar 04 2019 09:57:20 GMT+0100 (czas środkowoeuropejski standardowy)

G28; Dom

M401; wdrożyć sondę Z (pomiń, jeśli używasz bltouch)

G30 P0 X500 Y0 Z-99999; sonda w pobliżu śruby pociągowej

G30 P1 X500 Y500 Z-99999; sonda w pobliżu śruby pociągowej

G30 P2 X0 Y500 Z-99999 ; sondować w pobliżu śruby pociągowej

G30 P3 X10 Y10 Z-99999 S4; sondować w pobliżu śruby pociągowej i skalibrować 4 silniki

M402; wycofaj sondę (pomiń, jeśli używasz bltouch)

Hello, I read your forum and I did not find anywhere solved problem of 4 engines on the Z axis.

Someone can write the instructions

what to enter in config.g
and in bed.g

and where it is needed.

Instructions on how it should work.