@phaedrux Thank you for the suggestions! Everything checked out...and it turns out that the config was looking for the stepper on the other driver. Simple solution, so obviously I wouldn't think of it first!

@phaedrux Thank you for the suggestions! Everything checked out...and it turns out that the config was looking for the stepper on the other driver. Simple solution, so obviously I wouldn't think of it first!

Hi,
I purchased a Maestro expansion board from Filastruder back in January and just got it hooked up to my board to drive my extruder stepper. The problem is that when I go to extrude it clicks a little, pushes out little spots of filament, and returns the error “Warning: Driver 6 warning: phase A may be disconnected, phase B may be disconnected”. Looking at the board, I noticed that it won't seat fully onto the pins, and am wondering if there's something wrong with the board itself or some trick to getting it to properly seat.