Topics created by AlexTheGreat

FYI, If you want to avoid high currents on the duet board or it's green terminals, you can use an external DC SSR or power MOSFET.

You can find some information here https://duet3d.dozuki.com/Wiki/Choosing_a_bed_heater

@bearer I got it all working. Thank you very much!!

@Veti It's flying along like a bat out of hell now! Thanks!

There is quite a bit of documentation that may help you along.

https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_BLTouch
https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCartesianPrinter#Section_Homing_files

Please post your config.g and homing files.

@kostasbmw said in Error:short-to-ground/over temp shutdown reported by driver 0:

today i transfered my duet to a new corexy build and before i go on i wanted to test the movement..after connecting i had movement but in the wrong way...so i sent a m564 to check each motor separately...Z all ok disconected z wiring plug in X movement but i get the short to ground driver 0 error.....unplugged everything and click on x to move i get the same message.....is that normal?????note that i running the 2.04 firmware

ok