Height map makes my bed look warped…Why???
-
Things where great near the center, but out near the edges it went right off the bed. I guess it
changing the arm length by 14mm was not the best -
How big is your bed?
-
try 8 factor cal
-
Is there a list somewhere of what the different factors are? i saw one once but it only went up to 7.
-
https://duet3d.com/wiki/Calibrating_a_delta_printer
found it, going to give 8 a try
-
I think that is better, you can even see on the heightmap where i have binder clips holding the heatspreader plate down.
Calibrated 8 factors using 17 points, deviation before 0.087 after 0.056
-
Earlier you said it went off the bed. Are you saying it tried printing off the edge of the bed? Is your build plate 270mm+?
-
it actually went off during a calibration not a print, the first time through the calibration it looked good, later it went off the edge, yes the bed itself is 310,
-
Is this a Rostock, by chance?
-
in concept yes…but i think the heat bed is the only actual real rostock part,
