m122
=== Diagnostics ===
RepRapFirmware for Duet 2 WiFi/Ethernet version 3.6.0-rc.2 (2025-03-31 12:15:44) running on Duet WiFi 1.02 or later + DueX5
Board ID: 08DLM-996RU-N85S4-7JKDJ-3S06L-98BVP
Used output buffers: 7 of 26 (26 max)
=== RTOS ===
Static ram: 24016
Dynamic ram: 74128 of which 12 recycled
Never used RAM 21288, free system stack 114 words
Tasks: NETWORK(1,ready,24.6%,203) HEAT(3,nWait 5,0.1%,328) Move(4,nWait 5,0.1%,268) DUEX(5,nWait 5,0.0%,18) MAIN(1,running,75.0%,657) IDLE(0,ready,0.2%,29), total 100.0%
Owned mutexes:
=== Platform ===
Last reset 00:43:10 ago, cause: software
Last software reset at 2025-04-29 09:42, reason: User, Gcodes spinning, available RAM 23056, slot 0
Software reset code 0x0003 HFSR 0x00000000 CFSR 0x00000000 ICSR 0x00400000 BFAR 0xe000ed38 SP 0x00000000 Task MAIN Freestk 0 n/a
=== Storage ===
Free file entries: 9
SD card 0 detected, interface speed: 20.0MBytes/sec
SD card longest read time 5.0ms, write time 43.0ms, max retries 0
=== Move ===
Segments created 23, maxWait 171789ms, bed comp in use: mesh, height map offset 0.000, hiccups added 0/0 (0.00ms), max steps late 1, ebfmin 0.00, ebfmax 0.00
Pos req/act/dcf: 101969.00/101969/0.00 -8763.00/-8763/-0.00 30306.00/30306/0.00 657.00/657/0.50
No step interrupt scheduled
Driver 0: standstill, SG min 0
Driver 1: standstill, SG min 0
Driver 2: standstill, SG min n/a
Driver 3: standstill, SG min 0
Driver 4: standstill, SG min 0
Driver 5: standstill, SG min 0
Driver 6: standstill, SG min 0
Driver 7: standstill, SG min 0
Driver 8: standstill, SG min 0
Driver 9: standstill, SG min 0
Driver 10: 
Driver 11: 
=== DDARing 0 ===
Scheduled moves 1508, completed 1508, LaErrors 0, Underruns [0, 0, 0]
Segments left 0
Code queue is empty
=== Heat ===
Bed heaters 0 -1 -1 -1, chamber heaters -1 -1 -1 -1, ordering errs 0
Heater 0 is on, I-accum = 0.1
Heater 2 is on, I-accum = 0.4
=== GCodes ===
Movement locks held by null
HTTP is idle in state(s) 0
Telnet is idle in state(s) 0
File is idle in state(s) 0
USB is idle in state(s) 0
Aux is idle in state(s) 0
Trigger is idle in state(s) 0
Queue is idle in state(s) 0
LCD is idle in state(s) 0
Daemon is idle in state(s) 0
Autopause is idle in state(s) 0
=== DueX ===
Read count 48, 1.11 reads/min
=== Network ===
Slowest loop: 211.87ms; fastest: 0.00ms
Responder states: HTTP(0) HTTP(0) HTTP(0) FTP(0) Telnet(0)
HTTP sessions: 1 of 8
=== WiFi ===
Interface state: active
Module is connected to access point 
Failed messages: pending 0, notrdy 0, noresp 0
Firmware version 2.2.1
Module reset reason: Turned on by main processor, Vcc 3.37, flash size 4194304, free heap 39336
MAC address 98:f4:ab:d1:f3:ec
IP address 10.250.250.90
Signal strength -73dBm, channel 1, mode 802.11n, reconnections 0
Clock register 00002002
Socket states: 0 0 0 0 0 0 0 0